#Realized what i was missing, a good reference for audio setting adjustments lol ->
; Leave this set to 0 for USB sound fobs modified using
; the instructions from usbfob.pdf. Use a setting of
; 1 is for Dingotel/Sph interfaces.
; 0 = 20db attenuator inserted, 1= 20db attenuator removed
; Set to 1 for additonal gain if using a low-level receiver output
;see rxboost above
; reduce talkoff from radios w/o CTCSS Tx HPF
; Do not change this, leave this as a 1
; default tx ctcss freq, any frequency permitted
; rx ctcss freqs in floating point. must be in table
; tx ctcss freqs, any frequency permitted
; Set to 1 or yes to start out in carrier squelch mode
; no - no carrier detection at all
; usb - from the COR line on the modified USB sound fob
; usbinvert - from the inverted COR line on the modified USB sound fob
; dsp - from RX noise using dsp techniques
; vox - voice activated from RX audio
; pp - parallel port (active high)
; ppinvert - parallel port (active low) Motorola via PNP/NPN
; no - CTCSS decoding, system will be carrier squelch
; usb - CTCSS decoding using input from USB FOB
; (currently not supported)
; dsp - CTCSS decoding using RX audio in DSP.
; rxdemod option must be set to flat for this to work.
; no - RX audio input not used
; flat - Use RX audio from discriminator (before de-emphasis)
; speaker - use de-emphasized audio
; no - Audio is not pre-emphasized and limited.
; Suitable for use on a microphone input
; yes - Audio is pre-emphasized and limited.
; Suitable for direct connection to an FM modulator
; no - Audio is not limited.
; yes - Audio is limited.
; Suitable for transmitters with no limiting but with pre-emphasis.
; no - CTCSS tone encoding with no hang time
; phase - encode CTCSS and reverse phase
; AKA ("reverse burst") before unkeying TX
; notone - encode CTCSS and stop sending tone before unkeying TX
; AKA ("chicken burst")
; no - Do not output anything
; voice - output voice only
; tone - CTCSS tone only
; composite - voice and tone
; auxvoice - auxiliary voice output at headphone level for monitoring
;;txmixb= no,voice,tone,composite, auxvoice
; See txmixa above.
; Invert PTT
; 0 = ground to transmit
; 1 = open to transmit
; This is the collector lead of the 2n4401 on the modified
; usb sound fob.
; please refer to the howto for the procedure to do this.
; Full Duplex=1
; Half Duplex=0
; Uncomment and/or adjust for simplex nodes to eliminate "Ping Ponging"
; or "Relay Racing".
; A positive value here will instruct the usbradio driver to ignore the
; COR line for a specified number of 20mSec intervals following the
; release of PTT. Use this only on simplex nodes, and leave commented
; out for repeaters or other full duplex nodes.
; EEprom installed on USB Fob
;Dont forget to check your radio tune settings k5TRY